J1 and J2 assembled
Memory
One SATA connector
One USB Flash disk slot
Via one USB onboard connector
One microSD™ card slot
Graphics
One DVI-I connector
Analog VGA signals via LVDS interface
I/O
Four USB 2.0 host connectors, one optionally usable as client
10/100Base-T Ethernet
Two interfaces on RJ45 connectors
Audio
Audio in
Audio out
Via 3.5mm jack
RS232/RS422/RS485
One interface via 9-pin D-Sub connector
Configurable via software
TTY
Max. transfer rate 4800 bit/sec
Active or passive
Electrically isolated
GPIO
8 lines on a 10-pin connector (5V level, for connection of an SA-Adapter™)
16 lines on an 18-pin connector (3.3V level)
One PCI Express® Mini Card slot
With SIM card slot
Via one PCI Express® x1 links and one USB port
Miscellaneous
Goldcap
Battery holder
Power button signal on pin header
Reset in/out on pin header
Electrical Specifications
Supply voltage/power consumption:
ATX standard power supply via 4-pin connector
+5V, 2.1A max.
+12V (12V only for LVDS backlight), (depends on the display) 0.7A with SHARP LQ121S1LG61 (12.1" / 800x600) with full brightness
Power supply cable should have a cross section of at least 1.5mm²
MTBF: 683,499h @ 40°C according to IEC/TR 62380 (RDF 2000)
Mechanical Specifications
Dimensions: 146x102mm
Weight: 142g (without ESMini™ module)
Environmental Specifications
Temperature range (operation):
-40..+85°C (screened)
Airflow depending on ESMini™ module
Temperature range (storage): -40..+85°C
Relative humidity (operation): max. 95% non-condensing
Relative humidity (storage): max. 95% non-condensing
Altitude: -300m to + 2,000m
Bump: 10g/16ms
Conformal coating on request
Safety
PCB manufactured with a flammability rating of 94V-0 by UL recognized manufacturers
