All 4 channels electrically isolated from the system and from each other
UART Controller
4 independent full-duplex asynchronous 16C950 high performance UART channels each
128-byte FIFO for each transmitter and receiver
UARTs fully software compatible with industry standard 16C55x type UARTs
Data rates up to 115.2kbit/s
Readable FIFO levels
Automated in-band flow control using programmable Xon/Xoff characters, in both directions
Automated out-of-band flow control using CTS/RTS and/or DSR/DTR
Arbitrary trigger levels for receiver and transmitter FIFO interrupts
Programmable special character detection
5-, 6-, 7-, 8- and 9-bits data framing
Detection of bad data in receiver FIFO
Independent channel reset by software
Transmitter and receiver can be disabled
Transmitter idle interrupt
Sleep mode (low operating current)
Peripheral Connections
Via front panel on a shielded 25-pin D-Sub receptacle connector
Via carrier board (rear I/O)
M-Module™ Characteristics
Compliant with M-Module™ standard
A08, D08, INTA, IDENT
Electrical Specifications
Isolation voltage:
•
500V DC between isolated side and digital side
•
180V DC between the channels
•
Voltage between the connector shield and isolated ground is limited to 180V using a varistor; AC coupling between connector shield and isolated ground through 47nF capacitor
Supply voltage/power consumption: +5V (4.85V..5.25V), 200mA typ.
MTBF: 272,598h @ 40°C according to IEC/TR 62380 (RDF 2000)
Mechanical Specifications
Dimensions: conforming to M-Module™ Standard
Weight: 67g
Environmental Specifications
Temperature range (operation):
•
0..+60°C or -40..+85°C
•
Airflow: min. 10m³/h
Temperature range (storage): -40..+85°C
Relative humidity range (operation): max. 95% non-condensing
Relative humidity range (storage): max. 95% non-condensing
Altitude: -300m to + 3,000m
Shock: 15g/11ms
Bump: 10g/16ms
Vibration (sinusoidal): 2g/10..150Hz
Conformal coating on request
Safety
PCB manufactured with a flammability rating of 94V-0 by UL recognized manufacturers
EMC
Tested according to EN 55022 (radio disturbance), IEC1000-4-2 (ESD) and IEC1000-4-4 (burst)
Software Support
Linux driver
Windows® driver
VxWorks® driver
QNX® driver
OS-9® SPF driver
For more information on supported operating system versions and drivers see Software.
